|32 forum posts|
I have a I inch brass screw snapped of flush, about 1 1/2 inches into an internal right angle joint, which needs removing as I can't reposition the fitting. I have a screw extractor but can't get at the thing to use it. Any suggestions?
I have thought of using a plug cutter to drill down round the screw and re'plugging the hole afterwards, would that work?
|John F||19/05/2015 08:49:55|
48 forum posts
Joppy that sounds a good solution just make sure you use a suitable wood for the plug particularly if you have to put the screw back in the same place. I would also put a small flat on one side of the plug for excess glue to escape.
Please login to post a reply.
Want the latest issue of The Woodworker incorporating Good Woodworking? Use our magazine locator links to find your nearest stockist!
We're always happy to hear from you, so feel free to get in touch!